RR Auction: Space Exploration featuring Apollo 11

Group of space-related games and models, including: a sealed Monogram 'Young Astronauts' model kit for 1:48 scale Mercury and Gemini capsule...

Tremendous full-scale all metal replica of the Sputnik 1 satellite, measuring approximately 23? in diameter, with four removable antennae, each able t

Vintage 1:40 scale contractor's model of a Northrop T-38 Talon, measuring 13? in length, with bold colors and US Air Force decals. The model is ...

Fantastic 1:15 scale fiberglass model of a North American Aviation X-15 hypersonic rocket-powered aircraft, designated as "66672," measuri...

Aerobee Rocket Nose Cone tip, measuring 5.75? tall and 2.25? in diameter, set upon a 5? x 5? wooden plaque, with an engraved metal plate reading: &q...

Scarce Apollo Block I Command Module Flight Director Attitude Indicator (FDAI), contained in its original 8? x 8? x 9.75? housing. The original Honeyw

Engineering development model of the Apollo Block I/II VHF/AM radio, used in development and testing; these are identical to the flight units, but hav

Apollo Command Module Block II crew restraint harness assembly, consisting of two brown nylon shoulder straps interfacing with the restraint harness b

Apollo Block II Overcurrent Sensor and Transfer Switch. The early Apollo Block II Overcurrent Sensor measures 3.75? x 3.25? x 3.5?, with a Kinetics ta

Complete Apollo Block II Pulsed Integrating Pendulous Accelerometer Assembly complete with accelerometer and the suspension electronics, manufactured

Apollo Command Module Beta cloth temporary storage pouch assembly, measuring 15? x 7.25?, featuring a Velcro-secured elastic band at the top of the po

Apollo Command Module Beta Cloth Temporary Stowage Bag, measuring 14? x 27.5?, featuring a patch on the front reading, "Temporary Stowage."...

Red rubber Apollo Command Module Block II Sextant Seal Gasket, measuring approximately 22? x 14.5? x 1?, marked on the outer edge: "V36-321853,...

Apollo Command Module Earth Landing Sequence Controller, measuring 8.25? x 4.5? x 3?, bearing a large parts tag affixed to the top, reading: "I...

Apollo Command Module Flight Simulator Camera Control Panel used to simulate flight conditions as the crew trained, measuring 19? x 7? x 6?, with the

Rare Apollo Command Module Guidance & Navigation Computer Buffer, measuring 6? x 6? x 4?, with tags on two sides: one reads, "Unit, Compute...

Apollo Command Module PCM Signal Conditioner, measuring 14.5? x 14? x 9?, with ports on the top marked "J1" through "J18," with ...

Apollo CM sextant alignment bar, measuring 22.5? x .75? x .25?, marked in white text, "Sextant Alignment Bar," with alignment lines and nu...

Apollo CM/SM Umbilical Disconnect, measuring 9.75? x 10? x 2?, marked on the front: "V36-317167-11, 06362AAJ8543." The panel has several p...

Apollo Command Module Block II Up-Data Link (UDL) equipment measuring approximately 9 x 17.75 x 5.5, labeled “C28-1A103.” The unit has five connectors

Apollo Command Module LiOH Cartridge Case, measuring 16? x 24? x 6?, with two cover panels secured by six olive drab Velcro straps, marked with six ...

Interesting collection of actual and mock-up Apollo Command Module seatbelt parts. The actual parts comprise: two seatbelt buckles with "Push t...

Apollo Command Module Urine Dump Nozzle, measuring 8? long and 3? in diameter, with dark part numbers on the side, "UAL A197," and engrave...

Apollo CSM Data Modulator (Block II version), measuring 4.25? x 4.75? x 8.25?, with a Motorola tag on one end, reading: "Item Name: Data Modula...

Large Apollo Command/Service Module Electrical Power Distribution Assembly, measuring 18? x 21? x 8?, with a tag on the body, reading: "Box Ass...

Apollo CSM Flowmeter Test Set used for measuring gaseous oxygen and nitrogen, measuring 15? x 13.5? x 12?, marked inside the cover with a part number,

Apollo CSM Propellant Electrical Control Unit used to regulate a meter indicating the amounts of oxidizer and fuel in the spacecraft's propellan...

Rare electroluminescent display screen from a Block II Apollo Display and Keyboard Assembly (DSKY), measuring 3.25? x 4.5? x 1?, attached to a mountin

Apollo Emergency Detection System (EDS) Rate Gyroscope Package, measuring 7? x 6.75? x 3.5?, with a Marshall Space Flight Center tag on the top...

Group of four pieces of Deep Space Network ground support hardware, including: an Apollo Ground Tracking Deep Space Network (DSN) Correlation Filter,

Apollo Launch Escape Tower Canard Actuator, measuring 23? x 8? x 6.5?, with worn part numbers on the sides and bottom; the central piece is marked, ...

Apollo Lunar Mapping Camera Laser Altimeter Checkout Head used to check the operation of the laser rangefinder for the lunar mapping camera, 9.5? x 8?

Interesting Apollo Lunar Module Latching Propellant Valve complete with wiring, measuring approximately 6? x 5? x 2?, with a wraparound Parker Aircraf

Dark green early Apollo-era Primary Life Support System (PLSS) cable pouch, 10.75 x 6.25 x 2.5, comprised of durable nylon fabric with zipper and Velc

Apollo Saturn Spacecraft SLA LM Umbilical Retractor, measuring 10.25? x 8.25? x 7.75?, marked on the bottom with part numbers: "V34-590236-7 02...

Apollo Service Propulsion System (SPS) Engine Monitor Panel used as ground equipment, manufactured by North American Aviation, measuring 19? x 7? x 10

Apollo Signal Conditioner Chassis, measuring 24.75? x 8.75? x 5?, with an Autonetics tag on the front, reading: "Chassis, Event Module, ME 181-...

Apollo Spacecraft Jettison Controller Assembly, measuring 14? x 19? x 8?, with a tag on the top reading: "Controller Assy Spacecraft Jettison, ...

Apollo Environmental Control System (ECS) Fan used to provide ventilation of the Apollo space suits, measuring 7? tall and 6? in diameter, with an Air

An unflown earlier variant of a left-handed A7L glove, likely the training or backup EVA glove made for Commander Frank Borman and his Apollo 8 missio

Beta cloth Buddy Secondary Life Support System (BSLSS) stowage bag personally used by Commander Alan Shepard during training for the Apollo 14 mission

Rare collection of eight thermal protection system components in various geometric shapes, with five consisting of honeycomb patterns redolent of unab

Saturn V Launch Vehicle Digital Computer (LVDC) Memory Module, measuring 6.5 x 5.75 x 5.25, produced by IBM under NASA contract number NAS 8-11561. Th

Saturn J2 Engine Flowmeter, measuring 9? long and 4? in diameter, marked on the body with part numbers: "251216 Assy., S/N 4097987." The t...

Large Saturn V second stage S-2 oxidizer shutoff valve used as engineering test hardware, measuring 21? x 12? x 18?, marked on a black tag: "Pa...

Saturn V third stage S-4B hydraulic pump used as engineering test hardware, measuring approximately 11? x 7? x 18.5?, with a NASA George C. Marshall S

Saturn V S2 Stage 2A Solenoid Valve probably used as ground support equipment, manufactured by VACCO Valves, measuring 8? x 4? x 3?, marked on the cen

Apollo Command Module Environmental Control System (ECS) Component, measuring 14? long and 5? in diameter, marked on the side, "828097-1, SN 02...

Apollo Command Module Environmental Control System (ECS) Component, measuring 12? long and 4? in diameter, marked on the side, "DWO 24545, 8281...

Apollo Block I Command Module Signal Conditioner Power Supply, measuring 4.75? x 4.5? x 3?, marked: "Power Supply Module, 512-3124-032, Part of...