RR Auction: Space & Aviation

Apollo launch control panel for use in the firing room at the Kennedy Space Center. The purpose of this panel was to control and monitor the Launch Ut

Apollo Telescope Mount Strobe Light. Heavy square housing measures 8.5 x 8 x 7.5 with a single bulb recessed in the middle covered by a thin black scr

Apollo SI-B firing room ground support control panel. Panel measures 19 x 17.5 x 19 and is labeled along the bottom edge, “S-IB Measuring & RF.”...

Flight-ready Lunar Module deployment truss manufactured by Grumman Aircraft. This piece comprised part of the structural-mechanical assembly between t

Unused Apollo Lunar Module pyrotechnic battery, serial no. 311. Battery measures 6.75 x 2.5 x 3, with two sets of terminals attached to one end and it

Apollo lunar sample core drill bit. Heavy threaded bit measures 2.5? tall and 1? in diameter. One end of the bit has five small sharp metal wedges to

Neat and still-functioning Apollo LUT and Moble Crawler red warning light. Dome-shaped light measures 11? tall with its base measuring 11.5? wide, wit

Limited edition display with a 1.75? cut section of the Apollo Mobile Service Structure. Metal piece is encased in a 7.25 x 5 x 1 piece of Lucite alon

Two used Apollo Communications Control Unit Assembly adapters. Each adapter measures 16.5? long, with a male connector at one end, a female connector

Flight qualified Lunar Module fuel temperature gauge. Component measures 2 x 4.5 x 4.5, with a single read-out to monitor the fuel and oxidizer temper