1452

Civil War U.S. Contract Colt Model 1860 Army Revolver

Currency:USD Category:Antiques / Firearms & Armory Start Price:2,000.00 USD Estimated At:3,750.00 - 5,500.00 USD
Civil War U.S. Contract Colt Model 1860 Army Revolver
Colt Model 1860 Army revolver with four-screw frame manufactured in 1862. The revolver has a military blue finish on the barrel, cylinder, trigger guard and backstrap with casehardened frame , hammer and loading lever and brass trigger guard. The one piece grip is oil-finished black walnut. The revolver has the four-screw frame with shoulder stock cut-outs in the recoil shield and an indentation for the stock yoke is the bottom of the backstrap. Single letter, "L", "S" and "C" Ordnance sub-inspection marks are stamped on major components. The Ordnance final inspection mark consisting of the script letters "PB" in a rectangle is stamped on the lower left side of the grip. The top of the barrel is roll-stamped: "-ADDRESS COL. SAML COLT NEW-YORK U.S. AMERICA-" in one line. "COLTS/PATENT" is stamped in two lines on the left front of the frame. The cylinder is roll-engraved with the Texas navy battle scene, and "COLT' PATENT NO./PAT. SEPT 10th 1850". The serial number, "31081" invisible on the bottom of the barrel lug, frame, trigger guard, backstrap. The partial serial number "1081" is stamped on the cylinder. All of the visible serial numbers match. The butt is stamped "D. LYSINGLRR" (origin unknown). The Colt Model 1860 Army revolver was the primary handgun issued to the Federal cavalry during the Civil War.
BBL: 8 inch
Stock:
Gauge: 44 percussion
Finish: blue/casehardened
Grips: walnut
Serial Number: 31081


Fine. The barrel, cylinder and backstrap have a particially touched up (browning solution) smooth, gray-brown patina with traces of the original blue finish in protected areas. Approximately 90% of the roll-engraved naval battle scene is visible on the cylinder. The loading lever, frame and hammer retain at least 50% of the original casehardened finish with strong case colors. The brass trigger guard has an attractive, un-polished, patina. The frame screws and trigger have traces of the original niter blue finish and are free from screw-driver battering. The grip is fine with a legible Ordnance final inspection mark and minimal handling wear. Most of the safety pins are at least 50% intact and the percussion nipples and rear face of the cylinder have only light flash pitting. The serial numbers and the markings on the barrel, frame and cylinder are crisp. The action is tight and functions well. This is a solid example of a Civil War Colt Model 1860 Army revolver with very little firing wear.